You will soon find the spare parts for this product here.
Lithium battery for Blue Connect Astral 7015C001 for Smart Pool Analyzer. Official replacement lithium battery for Blue Connect smart water analyzer.
Compatible with Blue Connect (white) and Blue Connect Plus (blue) models.
▪ Lithium battery for Blue Connect Astral 7015C001 Original replacement lithium thionyl chloride battery for Fluidra's Blue Connect smart water analyzer.
▪ Approximate dimensions: 13 x 1.5 x 1.5 cm
▪ The battery has to be replaced approximately every two years under normal conditions of use.
▪ To ensure maximum battery life, Poolaria recommends putting the Blue Connect into standby mode when your pool is in hibernation (see the instruction manual for more information).
▪ Steps to follow to replace the battery:
1. In "Parameters" » "Blue Connect", press "Change battery".
2. Take the analyzer out of the water, remove the rubber ring and use cap, and place Blue Connect into the storage cap.
3. Dry it and start the procedure in a dry and clean place.
4. Remove the adhesive tape and unscrew the top of the device. This is a left hand thread. Unscrew clockwise. Remove the gasket and discard it.
5. Disconnect the white connector by pulling on the red and black wire. The battery is located at the other end of the cable. Press the plastic rod to release the battery and remove it by pulling the cable.
6. Place the battery in the bottom of the cavity until it locks. Then connect the connector.
7. Place the new gasket supplied with the battery into the threads on the top of the unit. Close the top. This is a left hand thread. Screw it counterclockwise.
8. Stick the new adhesive tape supplied with the battery and put the ring back on. Then replace the use cap and put your Blue Connect back into the water.
* High demand product. We recommend checking stock before placing an order. It may appear available to buy because there is a waiting list for orders, you must check the delivery time in the email adm@q-tech.es.
