You will soon find spare parts for this product here.
Lithium Battery for Blue Connect Astral 7015C001 for Smart Pool Analyzer. Official replacement lithium battery for Blue Connect smart water analyzer.
Compatible with Blue Connect models (white) and Blue Connect Plus (blue).
▪ Lithium battery for Blue Connect Astral 7015C001. Original replacement lithium thionyl chloride battery for the Fluidra Blue Connect smart water analyzer.
▪ Approximate dimensions: 13 x 1.5 x 1.5 cm
▪ The battery needs to be replaced approximately every two years under normal usage conditions.
▪ To ensure maximum battery life, Poolaria recommends putting the Blue Connect into standby mode when your pool is hibernating (see the instruction manual for more information).
▪ Steps to follow to replace the battery of the Astral Blue Connect:
1. Under "Settings" » "Blue Connect", tap "Battery change".
2. Remove the analyzer from the water, remove the rubber ring and usage cap and place Blue Connect into the storage cap.
3. Dry it and start the procedure in a dry and clean place.
4. Remove the adhesive tape and unscrew the top of the device. This is a left-hand thread. Unscrew it clockwise. Remove the gasket and discard it.
5. Disconnect the white connector by pulling on the red and black wire. The battery is located at the other end of the wire. Press the plastic rod to release the battery and remove it by pulling on the wire.
6. Place the battery into the bottom of the cavity until it locks into place. Then connect the connector.
7. Place the new gasket supplied with the battery onto the thread on the top of the unit. Close the top. This is a left-hand thread. Screw it in counter-clockwise.
8. Stick the new adhesive tape supplied with the battery and put the ring back on. Then replace the operating cap and put your Blue Connect back in the water.
