Lithium battery for Blue Connect Astral 7015C001

Lithium battery for Blue Connect Astral 7015C001

Lithium battery for Blue Connect Astral 7015C001 Smart Pool Analyzer. Official replacement lithium battery for the Blue Connect smart water analyzer.

Compatible with the Blue Connect models (white) and Blue Connect Plus (blue).

Features and benefits of the lithium battery for Blue Connect Astral 7015C001.

▪ Lithium battery for Blue Connect Astral 7015C001. Original replacement thionyl chloride lithium battery for the Fluidra Blue Connect smart water analyzer.

▪ Approximate dimensions: 13 x 1.5 x 1.5 cm

▪ The battery needs to be replaced approximately every two years under normal usage conditions.

▪ To ensure maximum battery life, Poolaria recommends putting the Blue Connect into standby mode when your pool is in hibernation (see instruction manual for more information).

▪ Steps to follow to replace the battery of the Astral Blue Connect:

1. In "Parameters" » "Blue Connect", press "Battery change".

2. Take the water analyzer out, remove the rubber ring and the usage cap, and place Blue Connect in the storage cap.

3. Dry it and start the procedure in a dry, clean place.

4. Remove the adhesive tape and unscrew the top of the device. This is a left-hand thread. Unscrew it clockwise. Remove the gasket and discard it.

5. Disconnect the white connector by pulling on the red and black wire. The battery is located at the other end of the wire. Press the plastic rod to release the battery and remove it by pulling on the wire.

6. Place the battery at the bottom of the cavity until it locks into place. Then, connect the connector.

7. Place the new gasket supplied with the battery onto the threaded part at the top of the unit. Close the top. This is a left-hand thread. Screw it on counterclockwise.

8. Attach the new adhesive tape supplied with the battery and replace the ring. Then, replace the user cover and place your Blue Connect back in the water.